Catalytic-System Cleaner

Pour additive into the LIQUI MOLY Pump-spray Bottle (part no. 3316). Pump up the pump-spray bottle. Establish access to the intake tract, ideally behind the turbocharger. Please note that the access must be located immediately behind the air-flow sensor. Start the engine and spray the additive into the intake tract in short bursts at medium engine speed (2,000–3,000 rpm). If the speed does not begin to fluctuate, the intervals between spraying can be lengthened. If engine speed fluctuates significantly (>700 rpm), shorten the spray duration. For fine atomization, check regularly that the pump-spray bottle has sufficient residual pressure. LIQUI MOLY cannot offer any warranty if the product is not used as specified in the product information or if dosing systems other than those indicated here are used. It is the responsibility of the user alone to verify the suitability of alternative dosing systems. For optimum cleaning of the fuel system, we recommend adding Catalytic-System Clean (Part no. 7110) to the fuel immediately after applying the additive. This will safeguard the cleanness of the complete engine system including the exhaust gas system.

Deposits in the catalytic converter based on manganese oxide cannot be removed.